Thank you for using the Bug section, using templates provided will greatly help the team reproducing the issue and ease the process of fixing it.
Are you using Developer Mode or made changes in it?
no
Have you disabled/removed all your mods and addons? If the issue still occurs with no mods and add-ons, please continue to report your issue. If not, please move this post to the Community Support section.
yes
Brief description of the issue:
All flight surfaces go up and down about halfway, when I press the right trigger the rudder shakes
I did play around with the sensitivity’s but put everything back to default but the issue is still there
Provide Screenshot(s)/video(s) of the issue encountered:
The Bug Reporting Hub is for posting suspected or confirmed bugs that other users are able to reproduce without duplicating an existing bug report. Using the template or providing all the relevant information about your bug and sim setup is required in order to provide valuable information, feedback, and replication steps to our test team.
If you are not sure if your issue is a bug or need further input from the community, please use the User Support Hub category. If the community can replicate your issue, first search the Bug category to see if there’s an existing topic. If it already exists, contribute to that report. Duplicate bug reports will be closed.
If you believe it is a new report and no duplicate exists, then create a new bug topic using the provided topic template.
All issues caused by or involving third-party addons/mods should be reported to the third-party developer. Assure that no addons/mods are used when reporting issues in Bug Reports.
There is a procedure to recalibrate the VelocityOne manually, moving each control axis through its full range of motion. I don’t remember off the top of my head how to enable it but I found it on the Turtle Beach support page.
Hi @Sparkamatrix. I think I know what you are describing…
If you go into the training mode on the turtle beach yoke does it show the axis movements only moving about half way or not utilizing the full throw of axis’? On the yoke screen it should show the axis light up the training bar depending how you manipulate the yoke or throttles. If they are not mirroring your inputs the yoke may be out of calibration and need to be recalibrated. If you think this is the issue I’ll send you the email I received with instruction for recalibration. Mine did this about a year and some months after over 600hrs.
Hi thinks for the reply, yeah I found the V1 re calibration page to and tried it and did not work,the bad thing is i plugged in my old Loitech extreme 3Dpro and it works no issues.
Hmmm that’s no good! The recalibration process is a bit tedious as you have to move each axis 3x for it to register.
If that’s not the case my next troubleshoot would be the cable. If you have another USB C that would work on the yoke give that a go, if you haven’t already!
Thank you for using the Bug section, using templates provided will greatly help the team reproducing the issue and ease the process of fixing it.
For anyone who wants to contribute on this issue, Click on the button below to use this template: