Checking to see if someone else is having this problem before I file a bug report.
I have many commands tied to my hardware VKB Controller - sample below.
Using the SR22, I can toggle the lights ON - Strobes, Landing, Nav. I can’t toggle them OFF. Which makes no sense because Toggle is supposed to cycle the status. In order to reverse them, I must click the virtual cockpit button.
I have a lot of functions bound to switches on my V1F and Boeing TCA Quadrants that work well and reliably on the few aircraft I have flown in 2024, albeit I have not flown the SR22T yet. The one control that is not working properly is the gear lever on the TCA: It will reliably raise the gear but will not lower it. Will have to look into this as that is most inconvenient!
You wouldn’t happen to have checked to see if input repetition is turned on in the sub-settings via the little gear on the right of the binding’s line?
I have had trouble with toggles when this has been set.
Longitude
VKB FSM-GA
14 Landing Lights - Toggle Landing Lights = don’t work
15 Strobe - Toggle Strobes = don’t work
16 NAV Lights - Toggle NAV Lights = don’t work
Also do not work clicking the overhead panel above the windshield.
The panel lights do click on & off.
Set the time to darkness but did not see them.
“input repetition is turned on”
I was thinking the same as I have had issues with repetition as well. If you time it right you can get it right but it is hit and miss.
You and I have the exact same hardware. So it’s consistent for you and I.
Toggle drone doesn’t work for me. It selects the drone initially but doesn’t go back to cockpit view on the 2nd press.
