Since the last update (#5) I have issue with my controllers. The axis responds really late like if I would have a big dead zone.
As you can see on the picture, I need to move the controller very far before it start moving in FS2020, which means it’s correctly detected in Windows 10 but not in FS. And this happens on my two controllers (Saitek Yoke and Logitech X56).
I also had a huge problem with recalibration of my Saitek yoke. There was a flat dead zone in the center and then the curve grew exponentially at either end. This affected both the X and Y access. I had to go in and re-set the sensitivity to flatten it out.
Thank you!
Yep that was it, not sure why I did not find the “SENSITIVITY” button previously…
But right that was completely modified. Now it’s all good.
The updates have taken out all my KB Mappings, eg: Camera to landing view, can add it back but still doesn’t work but works via the menu system… switch to VR (NUM- in my case) works only when it feels like it… Middle mouse button to look around cockpit doesn’t work at all now, even after remapping… where is their UAT? how can you screw something so basic as KB Mapping… unbelievable!.. I’m in IT have have been since IT pretty much started, I’d be fired on the spot for these stuff ups!..
