The other day I started up MSFS (this would have been on or around the 24th of June, give or take a day or two) and lo and behold, an update started pretty much all by itself (usually I get notified to go to the Store and a few other places). Since then, I have been having nothing but problems with my Honeycomb Bravo Throttle - to wit, the throttle interface with MSFS has been erratic and for all practical purposes inoperative. This occurs in pretty nearly all of the profiles that I have set up, and involves whatever axis I assign to throttles. The throttle in the sim will not conform to the hardware throttle position, and moves back and forth erratically. No conflicts are apparent (more than one action set to the axis in question)and this behavior follows the axis assignment that is, it will occur on any axis I connect to throttle. If that same axis is set to mixture it works fine.
The whole shebang works fine in XPlane, so it is not a hardware issue… Anyone have any idea what is going on?
Thank you for your post!
Your topic has been moved to the “Tech Talk” subcategory of General Discussion & Community Support.
The “Tech Talk” sub-category is meant for simmers to discuss, ask or answer any questions related to sim installation, performance, crashes (CTDs), graphics and optimization, hardware, peripherals, community folder/add-ons, and anything that falls under the umbrella of “running the sim”.
The General Discussion category is meant for discussions that fall outside of our other sub-categories.
Please check out these other categories for your future posts:
-
Aircraft
is where you discuss current or future planes coming to MSFS.
-
World
is where you discuss scenery, airports, and weather.
-
Aviate, Navigate, Communicate
is where you ask for help with flying.
-
Menus & Activities
is where you discuss activities (landing challenges, bush trips, etc), plus anything accessed by the menus including the Marketplace, settings, logbook, cameras, etc.
If you go into your Controllers page for your TQ, when you move the levers backwards, and forewards, for a given axis does the white line move smoothly from left to right? If you go into sensitivities, you should also see the white dot move up, and down the line smoothly also.