Logitech flight switch panel “recognisedand ready to go” in Win 10…
should it appear as L switch panel in Dev Manager?
but MSFS only shows Logitech yoke, and I want to map pitch trim and flaps to FS
How exactly do I do this, pleasey?
TIA
Cordialement
Steve Sanford Biggles
Are you talking about this?
As far as I know you can not map any switch, this panel works directly with the sim.
You can map pitch and flaps in the yoke or in the throttle quadrant
You can with external software, like SPAD or Axis and Ohs.
Hi!
Thanks for rapid reply…
At last I have got the Logitech Flight autopilot multipanel working, linked to MSFS-with flaps and pitch trim functioning-but still have no clue or insight as to how I eventually succeeded!
When I get more usb ports-I think the switch panel you imaged will work directly as well…
My difficulty is that even trying hard to follow Logitech’s setup instruction-I spend literally hours getting the throttle to function correctly
(devices do show up in Devices and printers, not Device Mangler)
and it takes several reboots before they function in the sim!
Thanks for your help…
Biggles Steve Sanford
Then your problem was with the multipanel not with the switch panel.
Adding Logitech panels I suggest you to connect them to a powered USB hub
I have all of mine, and a Streamdeck, and all primary flight controls connected to a single 17(?) port powered USB 3 hub.
Did you have to do any special installations?
I plan to buy 10 Flight Instrument Panels plus switch and radio
but specially for the 10 Flight Instrument Panels I read contradicting information,
I read that they only work on 2.0 USB and that you should not connect more than 4 per hub and hubs should not be deasy chained but plugged individually in a port into the PC
Even on the Logitech site it says that these are 2.0 usb.
Do you have any issues running them on the 3.0 usb with 17 ports? This would be so much easier and cleaner.
Amazon do a very neat pcie 7 port usb3 card!
I intially went round in circles-followed Logitechs suggestions-and after several times poking my wyes out-got both panels working! Persevere!
The theottle quadrant also needed fuddling-only gave half power-kept crashing
Needed mapping to an input wtc
Still dont know exactly how
I did it-but now gives full power
So brassed off I dont have enerfy to fly anywhwre!!!
I think
I reinstalled the Logitech deivwrs each time
I added another panel!