Hi all,
I’m currently flying the Piper PA-28 Dakota and I’m struggling to tune the comms 1 and comms 2 to the required frequencies, as the dial increases by 0.025. This makes it impossible for me to tune to departure on 135.005. It’s either 135.000 or 135.025, there is no in-between. Since I’m using Say Intentions, I have to click on the frequency via the SI menu instead of manually tuning, which ruins all emersion.
Is there a way to fine tune the comms or am I stuck with the .025 increments?
Hi, I don’t have FS2024 yet but if the com radio is set on the GNS530 you should be able to change this in the settings of the GPS.
-bring up the AUX page group and select the setup page
-set the cursor on COM configuration and hit (on the GPS)
-set channel spacing to 25kHz and exit by holding the clear button
-repeat the same procedure but select 8.33kHz this time
-exit via clear button
It should work normally now.
HTH Frank
Perfect! Thanks Frank.
I’m not very familiar with the GNS530-430 yet, so I wasn’t sure this was even possible.
Thanks again for the speedy response.
Hi, somewhere on this forum there are links to the manuals of the various GPS’s.
…
Found it. Here
Regards, Frank
