Problem with atc altitude

Bug Reporting Hub ATC, Traffic & NAVAIDs
, ,
1

Bug Reporting Hub ms-store msfs-2024 ATC, Traffic & NAVAIDs
When asked to increase the altitude the atc keeps increasing the altitude requested to no end

:white_check_mark: SIM INFORMATION

This is vital information for our test team, please do not skip it or your issue may not be able to be reproduced or fixed.

  • Microsoft Flight Simulator 2020 or 2024:

  • Version Build Number (Where do I locate that?):

  • 1.1.7.0

  • Game Platform (Exampe: Steam, Xbox, MS Store):

  • MS Store

:white_check_mark: ISSUE DESCRIPTION

  1. Did you remove all your community mods/add-ons? If yes, are you still experiencing the issue?
    No mods or addons installed

  2. Description of the issue:

Was flying at flight level 290 and wanted to change to flight level 400 after asking the atc for an increase of 10k feet and after acknowledging the instruction the atc gives another new flight level higher and asks again to acknowledge and never stops.

:white_check_mark: FREQUENCY OF ISSUE

How often does this occur for you? (Example: Just once, every time on sim load, intermittently)
sever times on one session

:white_check_mark: REPRODUCTION STEPS

Please list clear steps you took in order to help our test team reproduce the same issue.

1.start a free flight with a pre made plan
2.go to cruising altitude
3.ask the atc for an increase of altitude
4.acknowledge the instruction
5.The atc enters a loop

:white_check_mark: YOUR SETTINGS

If the issue still occurs with no mods and add-ons, please continue to report your issue. If not, please move this post to the User Support Hub.

  1. What peripherals are you using, if relevant:
    mouse and keyboard

  2. [PC Only] Are you using Developer Mode or have you made any changes to it?
    no

  3. [PC, MSFS 2020 Only] Are you using DX11 or DX12?
    dx12

  4. [PC Only] What GPU (Graphics Card) do you use?
    rtx2060

  5. [PC Only] What other relevant PC specs can you share?
    16gb ram
    intel 10300h

:white_check_mark: MEDIA

Please add a screenshot or video of the issue occurring.

bug
bug508×504 49.9 KB

[END OF FIRST USER REPORT]

:loudspeaker: For anyone who wants to contribute on this issue, Click on the button below to use this template:

Do you have the same issue if you follow the OP’s steps to reproduce it?
•

Provide extra information to complete the original description of the issue:
•

If relevant, provide additional screenshots/video:
•

2

Do you have the same issue if you follow the OP’s steps to reproduce it?
• Similar

Provide extra information to complete the original description of the issue:
• ATC assigned me an initial altitude of 2000’, then continuously instructed me to climb in 2000’ increments without end, eventually reaching FL950 before I gave up. I had selected FL390 in the flight planner and sent that to ATC. I also tried cancelling IFR and retrying with my flight plan, with the same results.

If relevant, provide additional screenshots/video:
•

ATC bug
ATC bug1920×1080 160 KB

3

Do you have the same issue if you follow the OP’s steps to reproduce it?
•

Provide extra information to complete the original description of the issue:
•

If relevant, provide additional screenshots/video:
• Same problem I have requested a lower altitude ATC accepts the request responds with the new altitude and then when I acknowledge ATC it reverts back to the old altitude. Additionally if I reask ATC to reduce alt it remembers what I asked before and reduces the altitude by the old request plus the addition of the new request and the cycle continues back to the orig alt

4

ha…
thats a good one