RESOLVED - Brake Pedals Stay Locked On when Applied

Discussion Hub General Discussion
1

Whenever I apply either brake pedal while taxing it stays locked On. If I apply both they both stay locked On and it is as though my parking brake is engaged. When only one locks the plane pulls in that direction. I don’t use any AI assist and it happens on ALL aircraft every time I use the sim. The MFG pedals that are assigned to axis commands worked fine for over a week then all of sudden this issue arose. I have cleared the assignment and reassigned them but that didn’t help. The only way to fix it is to toggle the parking brake On and then toggle it back Off every time I apply brakes to keep the aircraft moving. I have filed this issue with the Zendesk but was wondering if others are experiencing this issue as well.

Thanks in advance
Joe

UPDATE:
Issue Resolved
I went into my controls and cleared the “Left Brake Axis” and the “Right Brake Axis” and instead assigned “Left Brake” and “Right Brake” to my pedal axis and now it works as it did before.

2

This has been reported by others. Suggest you send this in to Zendesk and include as much information as you can about yourt settings and peripherals. Also recommend you attach a copy of your DXdiag.txt file (Run -> DXdiag -> Save All Information).

3

Try reversing the axis of your brakes. (Click checkbox)

4

Are you sure the button is set for brake and not parking brake.
The default configuration for my flight stick had parking brake on the trigger so I had to remap it.

5

I’m sure all is set correctly because everything worked well for over a week.

Reversing does what one would think the brakes are on when not applied and immediately I have the issue of them now locked without applying brakes.

I’m very experienced in setting up flightsim control systems and am quite sure everything was setup fine and as I said it all worked well for quite some time then with no changes it just started to act like this when I launched the sim 2 days ago.

Joe