I have created a bush/dirt strip airport. Everything works and it looks fine when taxiing and flying, but in the World Map view where you choose an airport/ramp to fly out of, the runway is extremely wide and short and displaced to the south. The ramps also show up on top of the runway instead of sound of them where they should. I can’t figure out what I’ve done wrong.
I think it’s because the UI has a set width for for runway. Meaning you can only adjust the length of the runway. So when you create a short runway such as this, the width stays the same so it looks like a thicc rectangle.
And the close proximity of the parking spots to the runway made it appear to be superimposed on top of it.
Is there a difficulty in selecting the parking on the world map? If it’s still selectable I think it should be fine. If it’s difficult to select, you might need to move the parking spot further to the south away from the runway UI.
Thanks for the reply. There are several airports nearby that have narrower runways in the World Map. The runway is fairly narrow (a pretty simple dirt strip) and as long as the dirt area above it. The airport is displaced to the south as well.
I don’t have much room to move the parking spots. As they are, they are hard to select (or even see) in the World Map. But there is no where else for them to go (there are no taxiways between the runway and ramps).
I’ll keep searching. Thanks again!