Question: X-plane works great with these devices (they are simple potentiometers) but since MS2020 doesn’t have the -100 +100 designation on the AILERON TRIM & RUDDER TRIM pre-configured by the programmers (other than for elevator trim), they won’t work. X-plane immediately initializes them and asks for them to be calibrated. Any suggestions are appreciated. I use the Saitek Logitech auto-pilot panel for elevator trim, however i use the 3D printed “Gear-Falcon” trim-wheel for Aileron Trim and Rudder Trim. These are trim-wheel devices that can be used for all three trims if you so desire, he even has a new one with all three wheels built into one panel. I just have two separate ones. But to continue, I can’t get the aileron and rudder trims configured in CONTROLS due to the fact that it doesn’t have the -100 to +100 setting when configuring like the elevator trim has. It DOES recognize the “Gear-Falcon” device but on Aileron Trim and Rudder trim MS2020 only has “Left Aileron Trim”, “Right Aileron Trim” , “Left Rudder Trim” , and “Right Rudder Trim” and the trim doesn’t work properly since there is no slider showing up. Gear Falcon trim wheels are great and I know I am just doing something simple wrong. (or Asobo hasn’t programmed Aileron trim & Rudder trim correctly yet for trim-wheels). Thanks in advance with any help on this!!