Hello, I’m connecting my Honeycomb Bravo to MSFS 2024 using SPAD Next, but when I use my AP selection knob to select the button so I can assign it, it only selects the one I want if I go one notch below it. However, When moving the selector notches up it selects the one it’s on. This is a problem because I can’t select the IAS knob on my honeycomb bravo. Because it only selects the button if I put the knob on the notch below it, or it only selects the button if I move the notch up. Because the IAS is the bottom notch it isn’t possible. Here’s a SS of what is looks like when I put my notch on IAS and it still has the CRS notch selected.
Did you import one of the snippets to see how they did it? You don’t have to save the configuration you download, but it helps show you if you have a differing, perhaps non-working control binding.
Before I start any new setup on the Bravo I always check to see what others have done - most often I end up with a much better solution I could’ve done for myself with much less time.