There is a double run of the axis…try to take off with Cessna.. not xcub…the plane remain braked and only If I press slightly the brake it goes..I will send a screen shot
I’m having the exact same misbehavior with the toe brakes on CH Pro Pedals … i.e., even though pressing the pedals moves the bar properly in the main controller assignment screen, the Sensitivity screen and the game itself think the “0” position is at 50% depression of the pedals, not at one end of the travel. And the toe brakes work perfectly in other games, so I don’t believe it to be a calibration issue.
TL;DR
T-Flight Rudder users: make sure your adapter’s selector switch is set to the AIRPLANE position.
I spent a little over an hour combing through the fixes listed in this thread (big thanks!) and my Y-Axis Slider option wouldn’t populate in Flight Sim. While going through the uninstall/reinstall procedures for the driver, I scoped the user manual (http://ts.thrustmaster.com/download/accessories/Manuals/TFRP/TFRP_User_Manual.pdf)The adapter’s selector switch was set to the RACING position.
I figure if I missed it, maybe someone else out there did too.
did you check the box “reverse axis” for the brakes? if it is not checked the brakes are always engaged and disengage when you press on the pedals
My tfrp is set to airplane and is set with reverse…but nothing…in other games it works…works with some airplanes in fs but not with most of the airplane…
My 0 is set at 1/4 because I have double run of the dot…the dot start right high ..Go down left and return high right all in a single entire pressure of one of the toe brakes
My rudder works when i press the pedal until it reach the center zone…Note that the lenght of the dot is a 1/4…this mean that the dot go down and return high right until the end of pressure…The rudder works correctly but the toe brakes not
I’m having the same issue.
Guys, I did everything as described, but nothing helps. Rudder works, no issues at all. But brakes are always on. And when I press the brakes, it releases them for a second and then presses them again all the way. When I remove me feet from brakes, it does again same thing thing: it releases them for a second and then presses them again all the way. Don’t know what to do with these pedals.
What else shall I try to make them work? I literally can’t taxi at all, unless I am on a too high speed.
Brakes must control the brake axis -not “on/off.”
I can confirm that one of the recent patches (December '20, January '21 timeframe) did indeed fix this issue, and I can now use my CH Pro Pedals toe brakes in analog mode. Thank you very much!