Hello, I am having trouble with the calibration. The throttles don’t go into idle, they get stuck at the CLB detent. Even if I push the throttle down to idle with my mouse, the EFB shows them very high. I am using Beta SU1, is this a bug? I tried deleting the INI file in the WASM folder, but that didn’t work. Deleted the aircraft folder so it can stream again, and that didn’t work. Ay suggestions are highly appreciated. Thanks.
This is for calibrating hardware throttles, but it sounds like you don’t have any. Otherwise what are you doing with your mouse?
This is so if I have hardware (which I do) for a throttle. it’s an axis. I physically move my hardware into the lowest position and click set idle (or if you have reverser like I do then enable that and select max reverse) then I physically move the controller hardware to the next spot and set clb, and so on and so forth, moving the IRL hardware to the desired position, then clicking the set X in the tab. once I close the tablet, I can move the physical hardware and look at the in-game throttle and the positions are correct to my hardware, so the clb in game is the same as clb IRL.
[edit] and to clarify a little further the green bars in the tablet represent where your IRL throttles are
1 Like
Yes I know, I’m using the bravo throttle. The problem lies in the EFB. My throttle Axis is all the way to the bottom in the idle position on my bravo, but the efb reads it at 50% and it wont go back down. I’m stuck. I moved it physically with the mouse to see if the efb showed 0%, but even then it reads 50%
You’re using throttle axis 100 0% right? If you want to set reverser you have to check the check box at the top of the tablet there.
Also the green is half way up because that’s the lowest value you’ve said it should go. If you choose reverser on axis you’ll see the reverser options below. It doesn’t matter that it looks 50% because that’s as low as the efb goes the way you have it. It will move the throttle from idle at lowest physical position then max and max. Why does it matter that it’s half way up the efb?
Re-reading your op, you need to set the climb detent further up your phsycial axis
The issue was in the Bravo Throttle, once changing the profile from blank to default it reset the Throttle Axis. Had it blank since I also use SpadNext. Thanks for all the help!
1 Like
I’m delighted it’s fixed haha!
1 Like