Throttles sometimes work backwards

[hobanagerik]

Does that throttle have an idle detent? If so you can set the Neutral point on your sensitivity axis to sit on the centre line when Neutral, and anything past that will be reverse.

Take a look at this:

Propeller reverse thrust set up

These are bindings I am using: [image] The bit that makes it work is on the sensitivities interface: [image] The “Neutral” setting specifies the point where you cross into reverse thrust. My TQ6+ has a detent for idle, so I simply rest both throttles at this detent, then adjust the “Neutral” point so that the dot as shown above rests on the horizontal line. Forward thrust is below the line, and the steeper curve above the line is reverse thrust. No button necessary, and you can alter the…