Thrustmaster Airbus throttle reverses don't work properly

[NeoKingRthur]

If you’re using the A32NX mod EFB calibration, make sure you have it set up properly.

1. Do a proper hardware calibration if you haven’t done so. You can find how to do them properly here.

Thrustmaster Airbus Quadrant - throttle axis gone crazy!

I think it’s just a calibration error. Even if you return it and get an exchange, you would still have the risk of getting another uncalibrated hardware, which will make you end up back to square one while you’ve done all that effort of returning it, only for you getting the same issue again. You just need to update firmware and do a recalibration process yourself for to eliminate everything that needs to be eliminated before returning it. But first, you need to install the drivers and the Fir…

2. Once you done so, in the MSFS Control Settings, make sure you start with the default bindings, and create a duplicate profile from it.
3. Open your Sensitivity Curve, and press the Reset button, to make everything into fully linear sensitivity.
4. When you load a flight in A32NX Mod, make sure you enable Reverse On Axis on the top part of the EFB Calibration page.
5. Then set your Detents accordingly and make sure you have the Full Reverse, Idle Reverse, and Idle set up in ascending value respectively.