Hi there. I am using this joystick controlling the heli H135, but I am confused how to set the sensitive in the MSFS2020 settings. I tried a lot of different values, but the heli is a bit difficult to control while flying. The throttle of the stick is set for the collective and works fine, but the other axis is creepy. Is there anyone who can tell me his settings so I can compare a bit? Thanks…
I am brand new to flight sims, I had similar issues. My sidewinder pro was just too flighty and seemed uncontrollable. After setting a few tweaks its heading in the right direction.
This is my rudder yaw axis settings. I found the plane was wandering. Adding a dead zone fixed that. The plane now does not react until I move the Z axis more than the initial lean in either direction.
I fixed the jerkiness by adding a slow increment at the start also. So the increment curve becomes more aggressive the further I push/pull on the axis.
I take it you already recognise that elevator trim and speed can have a dramatic effect on control also.
GL setting up.
Thank you very much. The rudder axis works fine with the TCA sidestick but I will try also your settings. The other cyclic axis is worst. I can fly but hovering the Helicopter is hard, so I guess to play with settings more maybe somebody can assist with his settings, it would be fine ;-), Werner.