The yoke on my V1 has suddenly stopped working correctly.
It’s nothing to do with the sim setup - the same happens when I use USB Game Controllers in Windows.
Instead of getting a proportional response, the yoke behaves like a switch in both roll and pitch, ie goes directly from one extreme of travel to the other.
I’ve pulled the top off and the only oddity I could find was two c. 1cm wide e clips dropped out but I can’t see where they come from. Given the lack of obvious hardware problems (yes, the magnets are in place) I’m wondering if it’s some weird config problem.
However I’ve tried resetting and recalibrating to no avail. Note I’m running firmware 1.50.
Any ideas?