Hi , I have a problem with my Velocityone flight after an unsuccesful firmware update as my PC decided shutdown during the update . I now have a dead Yoke , nothing lights up , no screen or anything , I removed my yoke off my Flight sim platform so I could plug it directly into my pc Some forums stated but still dead , in device manager I looked at the drivers and get an error stating Synthectic Gamepad , I have removed said driver , but as soon as I plug back in the Flightone it comes back , also if I hold down the lower buttons on the yoke and plug it back in the Status indicater panel flashes red . I have reached out to turtle Beach and they asked me to send Videos which I have , Had A reply off Turtle Beach but are unable to help as I purchased it from Ebay and not official store , Thanks in Advance
Hi @Straycatuk
Have you tried these steps, in sequence:
1 VelocityOne Flight - Updating the Firmware
2 VelocityOne Flight - Device Unresponsive, Stuck In Update Mode
3 VelocityOne Flight - Recovery Process
If you have, and all 3 fail, then the yoke may not be able to recover from the failed update.
Hi , I havent tried all 3 steps but will try them in that order , I will post any updates ,
thanks for the quick reply
Thank you so much … Its funny I tried flashing the firmware several times but it would not flash , So I decided to unplug all of my usb stuff , VR goggles , powered USB Hub , Extra USB monitors etc … Removed any old drivers including XBOX gamepad drivers … And I would like to say My VelocityOne Flight is back up and running after a Succesful Firmware Update …
Thanks Again I really Appreciate the advice , Ian