Use of CH products Eclipse Yoke

Elevator Trim Control is effected using trim wheel # 15 and #16. Many, many wheel revolutions are required for a slight or perhaps no response. Other control assignments will work for trim. This yoke works perfectly on FSX. I suspect a specification in the software needs to be changed to make the wheel more sensitive.
Has anyone encountered and fixed this? Where is the MSFS software located? I cannot find it. Thanks all.

you have the cf control panel installed dont you.

not being funny just checking. :+1:t2:

Thanks. No I do not. It was not installed for FSX either. In discussions with CH Products tech support, they did not recommend it.

For your info I have the 29yr old CH yoke and pedals installed in 2020. Took me a couple of months to know what to do. Now that I have them installed I cannot fly a plane. No matter how much I calm the yoke down, it is not enough. Plane takes off, and within 30 seconds there is an unwanted aileron roll, then fighting up and down, and then down for good. Doesn"t make any sense as the yoke and pedals work like a champ In Prepar 3D v4&5 and steam. Even back in FS98. On another subject I wished someone would come out or up with a Glassair Aircraft. That would probably work great in 2020, as the plane uses a handheld controller, or stick likt airbuse uses. Anyway I got to hold one in my had when the pilot gave it to me and fly it doig 300 mph, I got nervous and gave it back to him. He built the airplane from scratch. If anybody knows how to calm a CH yoke down, I would like to hear for sure.