really now??what is going on?after the update the axis for throttle in tca Quadrant are inverted and wrong what is going on over there???
Just tick the Reverse Axis… what’s the big deal?
i did it and are still wrong CLB WRONG place etc…thats the big deal
Then just recalibrate the sensitivity. Again, not a big deal. If you need guidance on where you start, here’s mine. Use it as a base, and you can do minor adjustments to fit your specific quadrant.
the neutral needs to be on the negative.
-52% and -51%
Not 52% or 50%
Use Throttle 1 Axis (0 to 100%), and Throttle 2 Axis (0 to 100%)
Tick Reverse Axis.
And use the exact same sensitivity value as my screenshot. With the Neutral in the negative side.
u are right i did its real better but not going to idle thrust for that any idea what to change?the dead zone?
I start with neutral zone first. Put your thrust lever in idle position. And adjust the neutral zone until the thrust in the cockpit is set to idle. Then increase the deadzone to make sure it’s not jumpy to reverse when you put backward pressure on the lever while the detents are locked.
Just make sure you use the Throttle 1 Axis (0 to 100%), and Throttle 2 Axis (0 to 100%)
Not the Throttle 1 Axis or Throttle 2 Axis.
2 Likes
thank you very much for the help thats the solution !!!
glad I could help… Happy flying 
1 Like