ISSUE DESCRIPTION
Description of the issue:
Recently the older 787 model from 2020 became available in the Marketplace and I am used to this plane and quickly implemented it.
I also disabled the model in 2024, but there is a third entry in Base products for the 787 Family that cannot be disabled and I left it enables.
See these diagrams:
In this configuration the 2020 model works much better primarily on:
- FPS
- Clarity of cockpit instruments and labels
However, it will not fully use the data from the flight planner and this means that VNAV in not working as the Speeds and prescribed altitudes are not entered.
Nor is the ILS.
I did manually enter the ILS at SFO and it could fly a coupled approach properly.
I am asking if you can make the 2020 version autopilot capable of using the flight planner output so that VNAV and other aspects of the AP can be used.
FREQUENCY OF ISSUE
Always
REPRODUCTION STEPS
- Make a flight plan
- Enter it
- Look and very sparse VNAV entered
- ILS not activated
YOUR SETTINGS
None relevant
[PC Only] Are you using Developer Mode or have you made any changes to it?
No
[PC, MSFS 2020 Only] Are you using DX11 or DX12?
12
[PC Only] What GPU (Graphics Card) do you use?
3070ti
[PC Only] What other relevant PC specs can you share?
MEDIA
See above
[END OF FIRST USER REPORT]
For anyone who wants to contribute on this issue, Click on the button below to use this template:
Do you have the same issue if you follow the OP’s steps to reproduce it?
•
Provide extra information to complete the original description of the issue:
•
If relevant, provide additional screenshots/video:
•