Welcome! I have the CH Yoke too, but no petals. My display shows the ? too - that is the case for a lot, if not all, CH Yoke users. Like others here I went back and forth with CH Manager, and finally de-installed it and the yoke has worked great. As for the throttle, I use one lever for both Throttle 1 and 2 (Joystick L - Axis Z). Just search the forum and you’ll find a lot of info.
Welcome to the community.
I have never used the CH Manager with ANY of my simulators.
FS2020 certainly gave a new meaning to “Controller Confusion” It took me several days to figure out how to get the axis set up properly. I use the CH Yoke as well as the rudder pedals AND the Throttle Quadrant.
If there are any specific assignments you are looking for, and can’t find then online, then send me a PM and I can see if I can help.
I found out that I did not set the throttles and once I did they are working.
Watch those two videos, they will assist all having peripherals which don’t show up or work.
1 Like
Thanks for posting these here. These made the difference for me enjoying the Sim and throwing my hands up in frustration.
We are all on here to help each other, down the road, you will give me something I need, or one of the other folks will. It is great helping here.
I have the CH yoke and pedals and had assigned the controls and they seem to work good when I good to sensitivity but when flying thats all out the window and I’m all over the place with no control. Not sure what to try.
The steps in the videos above worked for me.
Hi guys
Has anyone got the CH products joke working? I mapped the aileron and elevation and in the settings menu i can see it working and moving according to the axis. But then has no actual effect on the aircraft
4 Likes
Same problem here
I set up mine OK, maybe you can post a screen shot of your bindings configuration.
Did you map to “aileron axis” and “elevator axis”?
In case you don’t know, don’t expect a graphic of the actual yoke, never been persent from 1st alpha.
Nothing is assinged. Everything is blank. Do i have to do it manually?
Yes, iirc, I discovered on first opening the sim that the yokes movements were recognised but NOT bound to any control axis. Make sure you bind to an “axis”.
There is a great YouTube vid by Squirrel specifically on configuring controllers and setting sensitivities and null zones.
5 Likes
I mapped the aileron and elevation axis yes but when I move them the actual Ailerons and elevators don’t move
1 Like
Did a new profile for the CH Yoke get created after mapping and saving?
Do you have any pic showing your yoke setup?
I don’t believe so. I will check as soon as I’m home from work
It shows the mapping in the settings. Just no effect on the actual plane
Did you get your CH Yoke setup?
You need to select the control and assign the axis to it
I have done this but still no luck for me