Anyone else having trouble with the new sensotivity curves? My issue is this:
First mm i move the joystick ot’s very twitchy. After that it’s nothing. Untill i hit the sensitivity cure where it goes straight again and it gives me full input. In other words: 1mm twitchy controls. Then almost nothing and then everything.
And they said they made it less twitchy… Also what s the point of the neutral setting? So we can choose to pitch up all the time or pitch down all te time? Really… That’s what we asked for?
Sorry asobo but this is just dumb. Also the curves look so weird and out of the ordinary. They’re not even symatrical.
Same here … Noticed straight after takeoff … Luckily was the C152 . Landed with a hop skip and jump. The SENSITIVITY settings and UI changed. Bedtime … that is another challenge for tomorrow to get it sorted.
I don’t think these settings are right for you either, there is a break in the curve in your picture as well. -10% is enough for you, but not for anyone else. I needed -85% for a smooth experience. Would you try to adjust to a value similar to ours, what kind of curve is drawn for you, please?
Just looking at the curves, -50% looks like what the ‘old’ -85% looked like.
The break in the curve is very useful. It gives you better control near the center of control surface deflection (most flying), but more deflection if you need it (aerobatics, etc). It’s a vast improvement on the old exponential curves.
Yes, there is something seriously wrong with how the settings affect the the curve calculation/formula after update 5.
Different exponential behaviour on different sides of neutral.
And certain settings, the control-surface will actually move backwards toward neutral the more you increase yoke input, this should not be possible at all.
PLEAASE, revert, and add linear sensitivity controls (min/max output)