Got a chance to review this. Anyone tried this yet? Microsoft Flight Simulator 2020 has embraced more Third Party players into the market. Hardwares are an essential part of flight simming. Shawn Byrne and his team of Flight Sim Stuff have recently come out with their next level hardware setup gear…

Nothing wrong with 3D Printed hardware if made correctly, I’ve got an H-Pattern/Sequential Gear Shifter that cost €100, it gets punished beyond belief but has lasted without fault for 4+ years now!

I already bought the Bravo Throttle Quadrant but this looks nice for GA, more authentic for the Cessna’s I’m currently flying.

Alternative TPM controllers with better construction, metal not plastic, are much more expensive.

I have the LG TQ and would love to replace with something that has a trim wheel or flap slot.ATM cannot even get a BRAVO TQ until the next few months and that isn’t guaranteed.Agreed overpriced for the quality.

The 3D print may just be for prototypes and not for production. (I don’t know.) But even if it is for production, 3D printing isn’t especially cheap if volumes are in that middle range between a few units a week to where true molding becomes economical. 3D printing can add lots of labor cleaning up …

They should print some wear and scratches.. rounded edges.. :smiley_cat: that looks more expensive :grin: (I’m thinking of trying a set of pedals but I have only experience with keyboard now..)

I dunno man, I’ve owned some logitech stuff. Someone else in here mentioned the 3d printed Sim Racing shifter, I think its the same one I have from SH in Spain, and its perfectly awesome. I’m not saying everyone can make a quality 3d printed product.. But I think its unfair just to light off about…

metal construction definitely gives a more solid feel but the price goes up. I just got my new Fulcrum Yoke last week. Slightly dearer than a Honeycomb but all metal with 180 degree aileron and full 8" elevator travel. Very solid bit of kit. far better than the Logitech/CH stuff which are really …

3D Printing is a very expensive manufacturing process.

Microsoft Flight Simulator Forums

Latest Flight Sim Hardware

Discussion Hub General Discussion

Nerbulus May 3, 2021, 5:22pm 2

This looks very expensive for something that looks 3D printed…

4 Likes