With update 5, settings were added to support the Thrustmaster TCA Quadrant Airbus Edition. It is greatly improved versus the manual mappings before, but there are still some notable issues with it. Buttons 7 and 8 are not mapped at all by default. This is the Engine mode selector knob. I can m…

Do you have settings for General Aviation planes?

software his here go to site support.thrustmaster and below page, you find software and download for quadrant and joystick

I hope this link and explanation works for you - download the pln file and rename it to pdf. When following the calibration instructions, you need to add and extra step between steps 7 and 8 - the CLB detent and the Full Reverse Stop. You need to enable the reverse thrust latches to stop you at the …

Thank you Mousketeer i will try

The same for me, any solution.?

[image] Issues setting up Thrustmaster TCA Throttle Quadrant Hardware & Peripherals 1.12.13.0. After two hours in the settings, I came to these. Almost perfect. [3]

I’m gobba take a look it tomorrow

Can you break the fix a bit better as its really confusing. I’m gonna take a tip from a other gentleman in adjustments in the settings then if thay doesn’t work ill try it your way. Can you make the steps for fixing it step by step so we can all see what we need to do. So basically can you write i…

Thank you for your configuration. Copied it and I am quiet satisfied! One question though: When my throttle levers of my quadrant are in the CLB position, I only have 80.4%. I have to push the levers a little bit more forward to get your 89%. Do I have to enter a lower DetentClimb value to compensa…

Perfectly working for me now using this setting: [image] Issues setting up Thrustmaster TCA Throttle Quadrant Hardware & Peripherals Okay, assuming that you have the 1.61 firmware and you have done a factory recalibration process on the hardware level so this is my settin…

Thrustmaster TCA quadrant still not completely working

User Support Hub Hardware & Peripherals

DraivPro December 23, 2020, 10:22pm 368

2 Likes