PA-28R Arrow III from Just Flight

[HerePorpoise437]

Don’t have the JF Arrow yet, but SpadNext might fix it. Payware though, unfortunately, but there is a trial. The issue sounds similar to the elevator trim problems discussed here:

Making trim easier, if you use Spad.Next

Cool fix of the day. Using Spad.Next to set the trim is a massive improvement over the default bindings. The default bindings move the trim one notch then a fraction of a second latter causes the trim to move a massive amount per second. It is near impossible to be precise with it. It also doesn’t seem to behave consistently or all aircraft. If you bind using Spad.Next’s repeat mode though you get a slower and much more precise trim change when holding down the button. I can change flap setting…